User Tools

Site Tools


correlator:axis_offset

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
correlator:axis_offset [2010/09/01 19:16]
cormac
correlator:axis_offset [2010/09/01 19:17] (current)
cormac
Line 54: Line 54:
 go go
 </​code>​ </​code>​
- 
 ===== Step 6 ===== ===== Step 6 =====
 Inspect the antenna table again. You should see Hobart listed as an EW mount with an axis offset of 8.195m. Inspect the antenna table again. You should see Hobart listed as an EW mount with an axis offset of 8.195m.
Line 61: Line 60:
 </​code>​ </​code>​
  
-Continue with your standard calibration. You should now have at least 3 '​CL'​ tables. You should find that the rate solutions in FRING vary only very slowly with time (at least for sources with good a priori positions).+Continue with your standard calibration. Note that CLCOR will modify the '​AN'​ table and create a new, modified, '​CL'​ table each time you run it. You should now have at least 3 '​CL'​ tables. Be sure to use this highest '​CL'​ table as the starting point for all ensuing calibration. You should find that the rate solutions in FRING vary only very slowly with time (at least for sources with good a priori positions).
correlator/axis_offset.txt · Last modified: 2010/09/01 19:17 by cormac