User Tools

Site Tools


lbaops:atcaobservingsummary

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
lbaops:atcaobservingsummary [2016/06/23 12:38]
chrisphillips [Troubleshooting]
lbaops:atcaobservingsummary [2016/06/23 12:39] (current)
chrisphillips [Troubleshooting]
Line 46: Line 46:
   *  **In 64 MHz mode, sampler stats are not close to ideal 17.3/32.6% range**: If the "​extreme"​ stats (usually around 17.3% are too large you need to **reduce** tied array gain. If the "​extreme"​ values are too small, you need to increase gain. On the caccc1:1 VNC, type "​tie"​ into the command window of cacor. Increase or decrease the gain in increments of 0.01 with the syntax ''​tie gain XX XX'',​ based on the value recorded when you just typed ''"​tie"''​   *  **In 64 MHz mode, sampler stats are not close to ideal 17.3/32.6% range**: If the "​extreme"​ stats (usually around 17.3% are too large you need to **reduce** tied array gain. If the "​extreme"​ values are too small, you need to increase gain. On the caccc1:1 VNC, type "​tie"​ into the command window of cacor. Increase or decrease the gain in increments of 0.01 with the syntax ''​tie gain XX XX'',​ based on the value recorded when you just typed ''"​tie"''​
   *  **cdisko freezes**: Try killing the GUI (via window manager or ^C fro starting terminal) and restarting. Killing the GUI should not interrupt the recording   *  **cdisko freezes**: Try killing the GUI (via window manager or ^C fro starting terminal) and restarting. Killing the GUI should not interrupt the recording
-  *  **DAS IF power level is out of range**: Adjust attenuation in loGUI (see above)+  *  **DAS IF power level is out of range**: Adjust attenuation in cacor (see above)
   *  **Recmon says recorder not connected**:​ See Recorder Notes   *  **Recmon says recorder not connected**:​ See Recorder Notes
  
  
lbaops/atcaobservingsummary.txt · Last modified: 2016/06/23 12:39 by chrisphillips