User Tools

Site Tools


lbaops:lbajan2007:v190f

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lbaops:lbajan2007:v190f [2007/01/24 12:46]
adeller
lbaops:lbajan2007:v190f [2015/12/18 16:38] (current)
Line 1: Line 1:
-===== v190f Setup:\\ =====+===== v190f Setup: =====
  
-^Description ​       | 18 cm disk-based pulsar astrometry |\\ +^Description ​       | 18 cm disk-based pulsar astrometry | 
-^Antennas ​          | Pa-At-Mp-Ho-Ti |\\ +^Antennas ​          | Pa-At-Mp-Ho-Ti | 
-^Start ​             | 27 02:​00:​00 ​  |\\ +^Start ​             | 27 02:​00:​00 ​  | 
-^Stop               | 28 02:​00:​00 ​  |\\ +^Stop               | 28 02:​00:​00 ​  | 
-^PI                 | Adam Deller |\\ +^PI                 | Adam Deller | 
-^Channel 1          | ''​ DAS #1 IFP#1-LO 1634 - 1650 MHz USB RCP  ''​ |\\ +^Channel 1          | ''​ DAS #1 IFP#1-LO 1634 - 1650 MHz USB RCP  ''​ | 
-^Channel 2          | ''​ DAS #1 IFP#1-HI 1650 - 1666 MHz USB RCP  ''​ |\\ +^Channel 2          | ''​ DAS #1 IFP#1-HI 1650 - 1666 MHz USB RCP  ''​ | 
-^Channel 3          | ''​ DAS #1 IFP#2-LO 1634 - 1650 MHz USB LCP  ''​ |\\ +^Channel 3          | ''​ DAS #1 IFP#2-LO 1634 - 1650 MHz USB LCP  ''​ | 
-^Channel 4          | ''​ DAS #1 IFP#2-HI 1650 - 1666 MHz USB LCP  ''​ |\\ +^Channel 4          | ''​ DAS #1 IFP#2-HI 1650 - 1666 MHz USB LCP  ''​ | 
-^Channel 5          | ''​ DAS #2 IFP#1-LO 1666 - 1682 MHz USB RCP  ''​ |\\ +^Channel 5          | ''​ DAS #2 IFP#1-LO 1666 - 1682 MHz USB RCP  ''​ | 
-^Channel 6          | ''​ DAS #2 IFP#1-HI 1682 - 1698 MHz USB RCP  ''​ |\\ +^Channel 6          | ''​ DAS #2 IFP#1-HI 1682 - 1698 MHz USB RCP  ''​ | 
-^Channel 7          | ''​ DAS #2 IFP#2-LO 1666 - 1682 MHz USB LCP  ''​ |\\ +^Channel 7          | ''​ DAS #2 IFP#2-LO 1666 - 1682 MHz USB LCP  ''​ | 
-^Channel 8          | ''​ DAS #2 IFP#2-HI 1682 - 1698 MHz USB LCP  ''​ |\\ +^Channel 8          | ''​ DAS #2 IFP#2-HI 1682 - 1698 MHz USB LCP  ''​ | 
-^DAS 1 Skyfreq ​      | 1650.00 |\\ +^DAS 1 Skyfreq ​      | 1650.00 | 
-^DAS 2 Skyfreq ​      | 1682.00 |\\ +^DAS 2 Skyfreq ​      | 1682.00 | 
-^Bandwidth ​         | 16 MHz         |\\ +^Bandwidth ​         | 16 MHz         | 
-^Recorder ​          | Disk             |\\ +^Recorder ​          | Disk             | 
-^DAS Mode           | vsop.pro ([[http://​www.atnf.csiro.au/​vlbi/​dasmodes/​16-2IF-1p-a.html|telescope]]) |\\ +^DAS Mode           | vsop.pro ([[http://​www.atnf.csiro.au/​vlbi/​dasmodes/​16-2IF-1p-a.html|telescope]]) |
-\\ +
-Ftp: [[ftp://​ftp.atnf.csiro.au/​pub/​people/​vlbi/​v190/​v190f]]\\ +
-----\\ +
-\\ +
-===== Comments:\\ ===== +
-\\ +
-**This is a disk based experiment. Do NOT delete the data after recording!!!!**\\ +
-\\ +
-Record on /​data/​removable or /data/xraid as appropriate\\ +
-\\ +
-The fringe check schedule has been incorporated into the v190f schedule - but don't forget to start the actual v190f recording separately!!!\\ +
-\\ +
-**TIDBINBILLA AND HOBART FREQUENCIES AND POLARISATIONS**\\ +
-\\ +
-Tid only has LCP at 1.6 GHz and should set up to record 4 channels of LCP at 256 Mbps using the vsop profile on the DAS, matched to the 4 channel frequencies given in the table. ​ This will allow Tid to match LCP at all 4 frequencies for the ATNF antennas.\\ +
-\\ +
-Likewise, Hobart should also set up to record LCP at 256 Mbps using the vsop DAS profile. ​ Like Tid this will allow LCP coverage of all 4 frequencies of the ATNF antennas, and will exactly match Tidbinbilla. ​ This setup will require splitting the RF signal and setting up two IF chains, one into each IFP of the DAS. \\ +
-\\ +
-^ IFP#1 Skyfreq ​      | 1650.00 LCP |\\ +
-^ IFP#2 Skyfreq ​      | 1682.00 LCP |\\ +
-\\ +
-**DAS & Recorder Setup**\\ +
-\\ +
-Hobart and Tidbinbilla connect DAS directly to VSIC as per normal\\ +
-\\ +
-Parkes, ATCA & Mopra connect both DAS to single VSIC input using '​Huygens'​ cable. DAS#2 should be configured to be the higher frequency and connected to input#2 (input with clock lines connected).\\ +
-\\ +
-Disk allocations are given below under the telescope specific notes.\\ +
-\\ +
-===== Observing comments for each antenna:\\ =====+
  
-| [[.:​v190fpalog | Pa]] | [[.:​v190fatlog | At]] | [[.:​v190fmplog | Mp]] | [[.:​v190fholog | Ho]] | [[.:​v190ftilog | Ti]] |\\ +Ftp: [[ftp://​ftp.atnf.csiro.au/​pub/​people/​vlbi/​v190/​v190f]] 
-----\\ +---- 
-===== Observing Logs\\ ===== + 
-[[http://​www.atnf.csiro.au/​cgi-bin/​vlbi/​parkes-onsource.pl?​session=Feb2006&​start=27/​02:​00:​00&​end=28/​02:​00:​00| Parkes onsource flagging]]\\ +===== Comments: ===== 
-[[http://​www.atnf.csiro.au/​cgi-bin/​vlbi/​mopra_onsource.pl?​exper=v190f| Mopra onsource flagging]]\\+ 
 +**This is a disk based experiment. Do NOT delete the data after recording!!!!** 
 + 
 +Record on /​data/​removable or /data/xraid as appropriate 
 + 
 +The fringe check schedule has been incorporated into the v190f schedule - but don't forget to start the actual v190f recording separately!!! 
 + 
 +**TIDBINBILLA AND HOBART FREQUENCIES AND POLARISATIONS** 
 + 
 +Tid only has LCP at 1.6 GHz and should set up to record 4 channels of LCP at 256 Mbps using the vsop profile on the DAS, matched to the 4 channel frequencies given in the table. ​ This will allow Tid to match LCP at all 4 frequencies for the ATNF antennas. 
 + 
 +Likewise, Hobart should also set up to record LCP at 256 Mbps using the vsop DAS profile. ​ Like Tid this will allow LCP coverage of all 4 frequencies of the ATNF antennas, and will exactly match Tidbinbilla. ​ This setup will require splitting the RF signal and setting up two IF chains, one into each IFP of the DAS.  
 + 
 +^ IFP#1 Skyfreq ​      | 1650.00 LCP | 
 +^ IFP#2 Skyfreq ​      | 1682.00 LCP | 
 + 
 +**DAS & Recorder Setup** 
 + 
 +Hobart and Tidbinbilla connect DAS directly to VSIC as per normal 
 + 
 +Parkes, ATCA & Mopra connect both DAS to single VSIC input using '​Huygens'​ cable. DAS#2 should be configured to be the higher frequency and connected to input#2 (input with clock lines connected). 
 + 
 +Disk allocations are given below under the telescope specific notes. 
 + 
 +===== Observing comments for each antenna: ===== 
 + 
 +| [[.:​v190fpalog | Pa]] | [[.:​v190fatlog | At]] | [[.:​v190fmplog | Mp]] | [[.:​v190fholog | Ho]] | [[.:​v190ftilog | Ti]] | 
 +---- 
 +===== Observing Logs ===== 
 +[[http://​www.atnf.csiro.au/​cgi-bin/​vlbi/​parkes-onsource.pl?​session=Jan2007&​start=27/​02:​00:​00&​end=28/​02:​00:​00| Parkes onsource flagging]]\\ 
 +[[http://​www.atnf.csiro.au/​cgi-bin/​vlbi/​mopra_onsource.pl?​exper=v190f| Mopra onsource flagging]]
  
  
lbaops/lbajan2007/v190f.txt · Last modified: 2015/12/18 16:38 (external edit)