User Tools

Site Tools


lbaops:lbajun2007:v209batlog

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lbaops:lbajun2007:v209batlog [2007/06/20 20:54]
elenc
lbaops:lbajun2007:v209batlog [2007/06/23 08:03]
adeller
Line 1: Line 1:
-Setup\\+Setup\ 
------\\\ +-----\
-\\\ +
-ATCA tied array should use antennas 1234 in CATIE (CA01, CA02, CA03 and CA04) - this gives a maximum baseline of 153m.\\\ +
-\\\ +
-(maximum baseline corresponds to ~3.6' at 13 cm.  The required field of view is less than 1', ~1/4 of the tied array beam)\\\ +
-\\\ +
-Default polarisations should be used in CATIE\\\ +
-\\\ +
-Use "​channels 1 - 8" in disko\\\ +
-\\\ +
-Connect DAS1 (2284 MHz centre) and DAS2 (2316 MHz) directly to VSIC1 via the Huygens cable to cavsi1\\\ +
-\\\ +
-Please start a new correlator log going for this experiment.\\\ +
-\\\ +
-Use one set of 7 x 500 GB drives (please record which ones)\\\ +
-\\\ +
-Observing comments\\\ +
-------------------\\\+
 \ \
 +ATCA tied array should use antennas 1234 in CATIE (CA01, CA02, CA03 and CA04) - this gives a maximum baseline of 153m.\
 +\
 +(maximum baseline corresponds to ~3.6' at 13 cm.  The required field of view is less than 1', ~1/4 of the tied array beam)\
 +\
 +Default polarisations should be used in CATIE\
 +\
 +Use "​channels 1 - 8" in disko\
 +\
 +Connect DAS1 (2284 MHz centre) and DAS2 (2316 MHz) directly to VSIC1 via the Huygens cable to cavsi1\
 +\
 +Please start a new correlator log going for this experiment.\
 +\
 +Use one set of 7 x 500 GB drives (please record which ones)\
 +\
 +Observing comments\
 +------------------\
 +Recording to ATNF V001 B1-B7.\
 +\
 +New tied array log was not started until UT 22:00\
  
  
lbaops/lbajun2007/v209batlog.txt · Last modified: 2015/12/18 16:38 (external edit)