User Tools

Site Tools


lbaops:lbajun2007:v209batlog

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lbaops:lbajun2007:v209batlog [2007/06/23 00:52]
guest
lbaops:lbajun2007:v209batlog [2015/12/18 16:38] (current)
Line 1: Line 1:
-Setup\\ +Setup 
------\\ +----- 
-\\ + 
-ATCA tied array should use antennas 1234 in CATIE (CA01, CA02, CA03 and CA04) - this gives a maximum baseline of 153m.\\ +ATCA tied array should use antennas 1234 in CATIE (CA01, CA02, CA03 and CA04) - this gives a maximum baseline of 153m. 
-\\ + 
-(maximum baseline corresponds to ~3.6' at 13 cm.  The required field of view is less than 1', ~1/4 of the tied array beam)\\ +(maximum baseline corresponds to ~3.6' at 13 cm.  The required field of view is less than 1', ~1/4 of the tied array beam) 
-\\ + 
-Default polarisations should be used in CATIE\\ +Default polarisations should be used in CATIE 
-\\ + 
-Use "​channels 1 - 8" in disko\\ +Use "​channels 1 - 8" in disko 
-\\ + 
-Connect DAS1 (2284 MHz centre) and DAS2 (2316 MHz) directly to VSIC1 via the Huygens cable to cavsi1\\ +Connect DAS1 (2284 MHz centre) and DAS2 (2316 MHz) directly to VSIC1 via the Huygens cable to cavsi1 
-\\ + 
-Please start a new correlator log going for this experiment.\\ +Please start a new correlator log going for this experiment. 
-\\ + 
-Use one set of 7 x 500 GB drives (please record which ones)\\ +Use one set of 7 x 500 GB drives (please record which ones) 
-\\ + 
-Observing comments\\ +Observing comments 
-------------------\\ +------------------ 
-Recording ​to ATNF V001 B1-B7.\\ +Recorded ​to ATNF V001 B1-B7 and SWIN V007 B1-B7. 
-\\+ 
 +New tied array log was not started until UT 22:00
  
  
lbaops/lbajun2007/v209batlog.txt · Last modified: 2015/12/18 16:38 (external edit)