User Tools

Site Tools


lbaops:lbanov2006:v189a

v189a Setup:

Description 18 cm imaging of 0521-365
Antennas At-Mp-Pa-Ho-Ti
Start 319 09:30:00
Stop 319 21:29:00
PI Emil Lenc
Channel 1 DAS #1 IFP#1-LO 1634 - 1650 MHz USB RCP
Channel 2 DAS #1 IFP#1-HI 1650 - 1666 MHz USB RCP
Channel 3 DAS #1 IFP#2-LO 1634 - 1650 MHz USB LCP
Channel 4 DAS #1 IFP#2-HI 1650 - 1666 MHz USB LCP
Channel 5 DAS #2 IFP#1-LO 1666 - 1682 MHz USB RCP
Channel 6 DAS #2 IFP#1-HI 1682 - 1698 MHz USB RCP
Channel 7 DAS #2 IFP#2-LO 1666 - 1682 MHz USB LCP
Channel 8 DAS #2 IFP#2-HI 1682 - 1698 MHz USB LCP
DAS 1 Skyfreq 1650.00
DAS 2 Skyfreq 1682.00
Bandwidth 16 MHz
Recorder Disk
DAS Mode vsop.pro (telescope)

Ftp: ftp://ftp.atnf.csiro.au/pub/people/vlbi/v189/v189a


Comments:

TIDBINBILLA AND HOBART FREQUENCIES AND POLARISATIONS

Tid only has LCP at 1.6 GHz and should set up to record 4 channels of LCP at 256 Mbps using the vsop profile on the DAS, matched to the 4 channel frequencies given in the table. This will allow Tid to match LCP at all 4 frequencies for the ATNF antennas.

Likewise, Hobart should also set up to record LCP at 256 Mbps using the vsop DAS profile. Like Tid this will allow LCP coverage of all 4 frequencies of the ATNF antennas, and will exactly match Tidbinbilla. This setup will require splitting the RF signal and setting up two IF chains, one into each IFP of the DAS.

IFP#1 Skyfreq 1650.00 LCP
IFP#2 Skyfreq 1682.00 LCP

DAS & Recorder Setup

Hobart and Tidbinbilla connect DAS directly to VSIC as per normal

Parkes, ATCA & Mopra connect both DAS to single VSIC input using 'Huygens' cable. DAS#2 should be configured to be the higher frequency and connected to input#2 (input with clock lines connected).

This is a disk-based experiment. DO NOT DELETE THE DATA.

The disk allocations for this experiment are recorded under the telescope specific notes, linked to below.

Observing comments for each antenna:

Observing Logs

lbaops/lbanov2006/v189a.txt · Last modified: 2015/12/18 16:38 (external edit)