User Tools

Site Tools


lbaops:lbasep2009:v316a

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lbaops:lbasep2009:v316a [2009/09/01 18:21]
sellings
lbaops:lbasep2009:v316a [2015/12/18 16:38] (current)
Line 24: Line 24:
  
 The purpose of these observations is to obtain the final epoch for proper motion observations of IRAS05011-6815 strongest methanol maser in the LMC.  Previous observations were made under the (now lapsed) v135 experiment code.  We are using the same observing mode as the v255 experiments,​ although there are no setup changes required for this experiment. ​ The maser has a peak flux density of about 3.5 Jy and should be at a frequency of 6662.55 MHz, but probably wont be visible online (except perhaps at Parkes and the ATCA). The purpose of these observations is to obtain the final epoch for proper motion observations of IRAS05011-6815 strongest methanol maser in the LMC.  Previous observations were made under the (now lapsed) v135 experiment code.  We are using the same observing mode as the v255 experiments,​ although there are no setup changes required for this experiment. ​ The maser has a peak flux density of about 3.5 Jy and should be at a frequency of 6662.55 MHz, but probably wont be visible online (except perhaps at Parkes and the ATCA).
 +
 ===== Observing comments for each antenna: ===== ===== Observing comments for each antenna: =====
  
 ==== Hobart, Ceduna :  ==== ==== Hobart, Ceduna :  ====
  
-The 4 x 16 MHz bandpass ​setup will require feeding two separate LOs into IFP#1 and #2 on the DAS/​frequency translator ​and splitting the LCP signal so that is feed into both sides For Hobart the LOs should be set to 468 MHz (IFP#1) and 810 MHz (IFP#​2) ​for the 4 x 16 MHz setup and 810 MHz for the 2 x 16 MHz setup.  For Ceduna, if you set the agilent to 11.1 GHz rather than 11.4 GHz, then you can use the same LOs as at Hobart.+The setup requires only a single LO split and feed into IFP#1 and #2 on the DAS/​frequency translator. For Hobart the LO should be set to 810 MHz (as for the higher frequency band for the v255f and g experiments).  For Ceduna, if you set the agilent to 11.1 GHz rather than 11.4 GHz, then you can use the same LO as at Hobart.
  
 ==== Parkes, ATCA, Mopra :  ==== ==== Parkes, ATCA, Mopra :  ====
 +
 +Leave frequency setup the same as v255 (ie DAS1 6316 MHz, DAS2 658 MHz). Choose Channes 5-8 in cdisko.
  
  
lbaops/lbasep2009/v316a.txt · Last modified: 2015/12/18 16:38 (external edit)