Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| difx:vex2difx [2021/08/05 12:44] – walterbrisken | difx:vex2difx [2021/09/16 22:36] – [SETUP sections] janwagner |
|---|
| | freqId | int list | | none | a comma separated list of integers that are freq table indices to select which bands to correlate; default is to correlate all. **Note:** this should be used to select parent bands for zoom frequencies if difx2fits is to be run. **Note2:** freq table indices usable for freqId are found in the .input file FREQ TABLE section | | | freqId | int list | | none | a comma separated list of integers that are freq table indices to select which bands to correlate; default is to correlate all. **Note:** this should be used to select parent bands for zoom frequencies if difx2fits is to be run. **Note2:** freq table indices usable for freqId are found in the .input file FREQ TABLE section | |
| | phasedArray | string | | | if specified, tells DiFX to produce a phased array output instead of cross correlations, using the setup specified in this phased array config file | | | phasedArray | string | | | if specified, tells DiFX to produce a phased array output instead of cross correlations, using the setup specified in this phased array config file | |
| | | outputBandwidth | float | MHz | none | if specified, enables DiFX 2.7 outputband mode and auto-determines bands that fit the VEX frequency setups | |
| | | addOutputBand | string | | none | if specified, enables DiFX 2.7 outputband mode and adds an explicitly specified outputband, syntax freq@<skye freq low edge MHz>/bw@<bandwidth MHz> | |
| |
| |
