kasi:rf
Table of Contents
MOPS/OCTAD RF Setup
General Notes
B6 atten defaults listed at /nfs/online/local/lo/B6_Attenuator_values.file
C26 mm Splitter RF should be < 2V
B6 input voltage should be 2V
B6 attenuation set as single number (A + B*16).
mm Selector 0..5
Receiver Setup
3mm
AntennaControl.send: setting mpacc.misc.turret.control.TRRTEN to 1 AntennaControl.send: setting mpacc.misc.turret.control.TRRT0 to 1 AntennaControl.send: setting mpacc.misc.turret.control.TRRT1 to 1 AntennaControl.send: setting mpacc.misc.turret.control.TransCtl to 2
7mm
AntennaControl.send: setting mpacc.misc.turret.control.TRRTEN to 1 AntennaControl.send: setting mpacc.misc.turret.control.TRRT0 to 0 AntennaControl.send: setting mpacc.misc.turret.control.TRRT1 to 1 AntennaControl.send: setting mpacc.misc.turret.control.TransCtl to 3
12mm
AntennaControl.send: setting mpacc.misc.turret.control.TRRTEN to 1 AntennaControl.send: setting mpacc.misc.turret.control.TRRT0 to 0 AntennaControl.send: setting mpacc.misc.turret.control.TRRT1 to 1 AntennaControl.send: setting mpacc.misc.turret.control.TransCtl to 1
Setup
- Put correct receiver on point (3mm, 7mm, 12mm)
- Set receiver RF switches
kasi/rf.txt · Last modified: 2021/04/26 15:16 by chrisphillips
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
