User Tools

Site Tools


lbaops:lbaaug2008:v255b

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lbaops:lbaaug2008:v255b [2008/08/05 10:21]
chris.phillips
lbaops:lbaaug2008:v255b [2008/08/07 16:22]
shaun.amy
Line 49: Line 49:
 ==== Hobart, Ceduna :  ==== ==== Hobart, Ceduna :  ====
  
-The 4 x 16 MHz bandpass setup will require feeding two separate LOs into IFP#1 and #2 on the DAS/​frequency translator and splitting the LCP signal so that is feed into both sides. ​ For Hobart the LOs should be set to 468 MHz (IFP#1) and 810 MHz (IFP#2) for the 4 x 16 MHz setup and 810 MHz for the 2 x 16 MHz setup. ​ For Ceduna, if you set the agilent to 11.1 GHz rather than 11.4 GHz, then you can use the same LOs as at Hobart.+The 4 x 16 MHz bandpass setup will require feeding two separate LOs into IFP#1 and #2 on the DAS/​frequency translator and splitting the LCP signal so that is feed into both sides. ​ For Hobart the LOs should be set to 468 MHz (IFP#1) and 808 MHz (IFP#2) for the 4 x 16 MHz setup and 808 MHz for the 2 x 16 MHz setup. ​ For Ceduna, if you set the agilent to 11.1 GHz rather than 11.4 GHz, then you can use the same LOs as at Hobart.
  
 ==== Hart :  ==== ==== Hart :  ====
Line 62: Line 62:
 | width=80% | width=80%
 ^ UT         | Channel selection ^ Parkes Frequency setup | ^ UT         | Channel selection ^ Parkes Frequency setup |
-| 02:​20-05:​57:​30 | 2,3,7,8 | 2008Aug_METH-split.cmd | +| 02:​20-05:​57:​30 | 3,4,7,8 | 2008Aug_METHc.cmd | 
-| 05:​57:​30-14:​36:​00 | 1-4     ​| ​2008Aug_METH.cmd | +| 05:​57:​30-14:​36:​00 | 1-4     ​| ​2008Aug_METHb.cmd | 
-| 14:​36:​00-15:​24:​20 | 2,3,7,8 | 2008Aug_METH-split.cmd |+| 14:​36:​00-15:​24:​20 | 2,3,7,8 | 2008Aug_METHc.cmd |
 | 15:​24:​20-16:​28:​20 | 1-4 | No Parkes | | 15:​24:​20-16:​28:​20 | 1-4 | No Parkes |
  
lbaops/lbaaug2008/v255b.txt · Last modified: 2015/12/18 16:38 (external edit)