lbaops:lbafeb2008:v190lholog
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
lbaops:lbafeb2008:v190lholog [2008/02/05 13:56] breid |
lbaops:lbafeb2008:v190lholog [2015/12/18 16:38] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | Recording to disks ATNF V010/A, partition 1 from 35/0100 to 35/1330 (disk ext2 label is AT_V010A_P1)\\ | + | Recording to disks ATNF V010/A, partition 1 from 35/0100 to 35/1330 (disk ext2 label is AT_V010A_P1) |
| - | \\ | + | |
| - | Recording to disks ATNF V010/A, partition 2 from 35/1330 to 36/0200 (disk ext2 label is AT_V010A_P2)\\ | + | Recording to disks ATNF V010/A, partition 2 from 35/1330 to 36/0200 (disk ext2 label is AT_V010A_P2) |
| - | \\ | + | |
| - | 2008.035.04:24:09.74;"antenna off source for last few minutes but OK again now\\ | + | The log from experiment v190l has been copied to: |
| - | \\ | + | ftp.atnf.csiro.au:/pub/people/vlbi/incoming/ |
| - | 2008.035.04:26:26.07;"problem was X2 pwr base fault. Fixed with: abort, drvoff, wait 5 sec, drvon - all in Vdesk. Then \\ | + | |
| - | onsource in FS oprin.\\ | + | ANTAB and UVFLG files have been copied to the same place. |
| - | \\ | + | |
| - | scan done on 1934 to calibrate Tsys prior to fringe check expt.\\ | + | |
| - | \\ | + | 2008.035.04:24:09.74;"antenna off source for last few minutes but OK again now |
| - | RX atten set to 13.75 dB\\ | + | |
| - | \\ | + | 2008.035.04:26:26.07;"problem was X2 pwr base fault. Fixed with: abort, drvoff, wait 5 sec, drvon - all in Vdesk. Then |
| - | Trombone 28 steps out from innner limit\\ | + | onsource in FS oprin. |
| - | \\ | + | |
| - | Agilent 4.0\\ | + | scan done on 1934 to calibrate Tsys prior to fringe check expt. |
| - | \\ | + | |
| - | 42 dB channel separation at 1666\\ | + | RX atten set to 13.75 dB |
| - | \\ | + | |
| - | SMX 702, SMY 670 MHz\\ | + | Trombone 28 steps out from innner limit |
| - | \\ | + | |
| - | 819.5 2nd Harmonic produces 5 Mhz on Ch1 band splitter\\ | + | Agilent 4.0 |
| - | \\ | + | |
| - | DAS profile VSOP_HO\\ | + | 42 dB channel separation at 1666 |
| - | \\ | + | |
| + | SMX 702, SMY 670 MHz | ||
| + | |||
| + | 819.5 2nd Harmonic produces 5 Mhz on Ch1 band splitter | ||
| + | |||
| + | DAS profile VSOP_HO | ||
lbaops/lbafeb2008/v190lholog.txt · Last modified: 2015/12/18 16:38 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
