Sidebar
lbaops:lbafeb2009:v289a
Table of Contents
v289a Setup lba21cm-2p-4IF:
| Description | eVLBI on Cir X-1 |
|---|---|
| Antennas | Pa-At-Mp |
| Start | 57 17:30:00 |
| Stop | 57 21:20:00 |
| PI | Steven Tingay |
| Channel 1 | DAS #1 IFP#1-LO 1384 - 1400 MHz USB RCP |
| Channel 2 | DAS #1 IFP#1-HI 1400 - 1416 MHz USB RCP |
| Channel 3 | DAS #1 IFP#2-LO 1384 - 1400 MHz USB LCP |
| Channel 4 | DAS #1 IFP#2-HI 1400 - 1416 MHz USB LCP |
| Channel 5 | DAS #2 IFP#1-LO 1416 - 1432 MHz USB RCP |
| Channel 6 | DAS #2 IFP#1-HI 1432 - 1448 MHz USB RCP |
| Channel 7 | DAS #2 IFP#2-LO 1416 - 1432 MHz USB LCP |
| Channel 8 | DAS #2 IFP#2-HI 1432 - 1448 MHz USB LCP |
| DAS 1 Skyfreq | 1400.00 MHz |
| DAS 2 Skyfreq | 1432.00 MHz |
| Bandwidth | 16 MHz |
| DAS Mode | vsop.pro (telescope) |
Ftp: ftp://ftp.atnf.csiro.au/pub/people/vlbi/v289/v289a
Comments:
This is an eVLBI experiment. Recorders are run remotely from from “pam0”.
Please set channel selection in cdisko to “Channels 1-8”. No other settings are needed.
To run:
ssh vlbi@pam0 cd correlations/v289/v289a ./run.sh
Parkes setup
Multibeam receiver. To set LOs use
lorun 2009Feb_MULTIa.cmd
Observing comments for each antenna:
Observing Logs
lbaops/lbafeb2009/v289a.txt · Last modified: 2015/12/18 16:38 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
