Sidebar
lbaops:lbajun2007:v209batlog
Setup
ATCA tied array should use antennas 1234 in CATIE (CA01, CA02, CA03 and CA04) - this gives a maximum baseline of 153m.
(maximum baseline corresponds to ~3.6' at 13 cm. The required field of view is less than 1', ~1/4 of the tied array beam)
Default polarisations should be used in CATIE
Use “channels 1 - 8” in disko
Connect DAS1 (2284 MHz centre) and DAS2 (2316 MHz) directly to VSIC1 via the Huygens cable to cavsi1
Please start a new correlator log going for this experiment.
Use one set of 7 x 500 GB drives (please record which ones)
Observing comments
Recorded to ATNF V001 B1-B7 and SWIN V007 B1-B7.
New tied array log was not started until UT 22:00
lbaops/lbajun2007/v209batlog.txt · Last modified: 2015/12/18 16:38 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
