Sidebar
lbaops:lbajun2008:v251b
Table of Contents
v251b Setup:
| Description | e-VLBI of nearby GPS candidates |
|---|---|
| Antennas | At-Mp-Pa |
| Start | 160 14:00:00 |
| Stop | 160 22:55:00 |
| PI | Tingay |
| Channel 1 | DAS #1 IFP#1-LO 8409 - 8425 MHz USB RCP |
| Channel 2 | DAS #1 IFP#1-HI 8425 - 8441 MHz USB RCP |
| Channel 3 | DAS #1 IFP#2-LO 8409 - 8425 MHz USB LCP |
| Channel 4 | DAS #1 IFP#2-HI 8425 - 8441 MHz USB LCP |
| Channel 5 | DAS #2 IFP#1-LO 8441 - 8457 MHz USB RCP |
| Channel 6 | DAS #2 IFP#1-HI 8457 - 8473 MHz USB RCP |
| Channel 7 | DAS #2 IFP#2-LO 8441 - 8457 MHz USB LCP |
| Channel 8 | DAS #2 IFP#2-HI 8457 - 8473 MHz USB LCP |
| DAS 1 Skyfreq | 8425.00 MHz |
| DAS 2 Skyfreq | 8457.00 MHz |
| Bandwidth | 16 MHz |
| DAS Mode | vsop.pro (telescope) |
Ftp: ftp://ftp.atnf.csiro.au/pub/people/vlbi/v251/v251b
Comments:
This is a eVLBI experiment
Using the following setup for I/O:
| Telescope | Recorder | Pam Host | Port | TCP window |
|---|---|---|---|---|
| ATCA | cavsi1 | pam2-ext2 | 52100 | 500 |
| Mopra | mpvsi2 | pam1 | 52101 | 1400 |
| Parkes | pkvsi1 | pam3 | 52102 |
Run the correlator with
> ./run.sh
The recorders must be started after the correlator (within 30sec).
ATCA (cavsi1)
vsib_record -p 52100 -H pam2-ext2 -W 450 -m2 -f 1s -o “ATCA” -t 12h
Mopra (mpvsi2)
vsib_record -p 52101 -H pam1 -W 1300 -m2 -f 1s -o “Mopra” -t 12h
Parkes (pkvsi1)
vsib_record -p 52102 -H pam3 -m2 -f 1s -o “Parkes” -t 12h
Observing comments for each antenna:
Observing Logs
lbaops/lbajun2008/v251b.txt · Last modified: 2015/12/18 16:38 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
