This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
lbaops:lbamay2005:vt03a1 [2005/05/12 21:35] stingay |
lbaops:lbamay2005:vt03a1 [2005/05/12 21:50] stingay |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== vt03a1 Setup:\\ ===== | + | ===== vt03a1 Setup:\ ===== |
- | ^Antennas | + | ^Antennas |
- | ^Start | + | ^Start |
- | ^Stop | 133 01: | + | ^Stop | 133 01: |
- | ^PI | Gulyaev/ | + | ^PI | Gulyaev/ |
- | ^Channel 1 | 1650 - 1666 MHz USB RCP |\\ | + | ^Channel 1 | 1650 - 1666 MHz USB RCP |\ |
- | ^Channel 2 | 1650 - 1666 MHz USB LCP |\\ | + | ^Channel 2 | 1650 - 1666 MHz USB LCP |\ |
- | ^Bandwidth | + | ^Bandwidth |
- | ^Recorder | + | ^Recorder |
- | ^S2 Mode | N/A |\\ | + | ^S2 Mode | N/A |\ |
- | ^DAS Mode | [[http:// | + | ^DAS Mode | [[http:// |
- | ^Buggary Cable | out |\\ | + | ^Buggary Cable | out |\ |
- | \\ | + | |
- | Ftp: [[ftp:// | + | |
- | ----\\ | + | |
- | \\ | + | |
- | ===== Comments:\\ ===== | + | |
- | \\ | + | |
- | ATCA and Mopra telescope schedules in place\\ | + | |
- | \\ | + | |
- | Parkes .psn schedule at ftp:// | + | |
- | \\ | + | |
- | Hobart VEX schedule at ftp:// | + | |
- | \\ | + | |
- | This experiment should be setup as per the normal fringe-checking proceedure (as was used for vt02d1) i.e:\ | + | |
\ | \ | ||
- | 1) Connect DAS to S2;\ | + | Ftp: [[ftp:// |
- | 2) Connect S2 to VSIC and on to disk-based recorder via BG2 cable;\ | + | ----\ |
- | 3) Use the following to record data: vsib_record -t 3h -c oxox -o <filename>\ | + | \ |
- | 4) | + | ===== Comments:\ ===== |
+ | \ | ||
+ | ATCA and Mopra telescope schedules in place\ | ||
+ | \ | ||
+ | Parkes .psn schedule at ftp:// | ||
+ | \ | ||
+ | Hobart VEX schedule at ftp:// | ||
+ | \ | ||
+ | To set this experiment up:\ | ||
+ | \ | ||
+ | 1) Connect DAS output | ||
+ | \ | ||
+ | 2) Change | ||
+ | \ | ||
+ | 3) Start recording: vsib_record -t 3h -s 2005-05-12T22: |