Sidebar
lbaops:lbamay2006:vt09a
Table of Contents
vt09a Setup:
| Description | X-band geodesy |
|---|---|
| Antennas | Cd-Mp-At-Ho-Pa |
| Start | 133 08:00:00 |
| Stop | 133 20:01:47 |
| PI | Chris Phillips |
| Channel 1 | IFP#1-LO 8409 - 8425 MHz USB RCP |
| Channel 2 | IFP#2-LO 8457 - 8473 MHz USB RCP |
| Sky Frequency | 8417, 8465 MHz |
| Bandwidth | 16 MHz |
| Recorder | S2 |
| DAS Mode | at16s.pro (or equivalent) |
| S2 Mode | 32×4-2 |
| Swap Cable | in |
| Tape Change | 133 13:59:44 |
Ftp: ftp://ftp.atnf.csiro.au/pub/people/vlbi/vt09/vt09a
Comments:
Check S2 time
Single pol dual frequency setup required. Will need special DAS setup.
Most antennas will need to feed Rcp (with a different LO frequency) into each IFP of the DAS). Narrabri will need to use the “Dual-head” buggery cable (not the huygens cable) to connect both DAS into the S2.
Schedules are on ftp area and have not been copied to observatories. PLEASE check schedule carefully. Tape stops may have to he removed from snap schedule after running drudge. Use the “centred” DAS profile which us usually used for dual pol experiments.
Observing comments for each antenna:
lbaops/lbamay2006/vt09a.txt · Last modified: 2015/12/18 16:38 by 127.0.0.1
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
