User Tools

Site Tools


lbaops:lbanov2006:v190d

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
lbaops:lbanov2006:v190d [2006/11/06 14:27]
adeller
lbaops:lbanov2006:v190d [2006/11/10 08:58]
stingay
Line 1: Line 1:
-===== v190d Setup:\\ =====+===== v190d Setup:\ =====
  
-^Description ​       | 18 cm disk-based pulsar astrometry |\+^Description ​       | 18 cm disk-based pulsar astrometry |\ 
-^Antennas ​          | Pa-At-Mp-Ho-Ti |\+^Antennas ​          | Pa-At-Mp-Ho-Ti |\ 
-^Start ​             | 322 11:​00:​00 ​  |\+^Start ​             | 322 11:​00:​00 ​  |\ 
-^Stop               | 323 11:​00:​00 ​  |\+^Stop               | 323 11:​00:​00 ​  |\ 
-^PI                 | Adam Deller |\+^PI                 | Adam Deller |\ 
-^Channel 1          | ''​ DAS #1 IFP#1-LO 1634 - 1650 MHz USB RCP  ''​ |\+^Channel 1          | ''​ DAS #1 IFP#1-LO 1634 - 1650 MHz USB RCP  ''​ |\ 
-^Channel 2          | ''​ DAS #1 IFP#1-HI 1650 - 1666 MHz USB RCP  ''​ |\+^Channel 2          | ''​ DAS #1 IFP#1-HI 1650 - 1666 MHz USB RCP  ''​ |\ 
-^Channel 3          | ''​ DAS #1 IFP#2-LO 1634 - 1650 MHz USB LCP  ''​ |\+^Channel 3          | ''​ DAS #1 IFP#2-LO 1634 - 1650 MHz USB LCP  ''​ |\ 
-^Channel 4          | ''​ DAS #1 IFP#2-HI 1650 - 1666 MHz USB LCP  ''​ |\+^Channel 4          | ''​ DAS #1 IFP#2-HI 1650 - 1666 MHz USB LCP  ''​ |\ 
-^Channel 5          | ''​ DAS #2 IFP#1-LO 1666 - 1682 MHz USB RCP  ''​ |\+^Channel 5          | ''​ DAS #2 IFP#1-LO 1666 - 1682 MHz USB RCP  ''​ |\ 
-^Channel 6          | ''​ DAS #2 IFP#1-HI 1682 - 1698 MHz USB RCP  ''​ |\+^Channel 6          | ''​ DAS #2 IFP#1-HI 1682 - 1698 MHz USB RCP  ''​ |\ 
-^Channel 7          | ''​ DAS #2 IFP#2-LO 1666 - 1682 MHz USB LCP  ''​ |\+^Channel 7          | ''​ DAS #2 IFP#2-LO 1666 - 1682 MHz USB LCP  ''​ |\ 
-^Channel 8          | ''​ DAS #2 IFP#2-HI 1682 - 1698 MHz USB LCP  ''​ |\+^Channel 8          | ''​ DAS #2 IFP#2-HI 1682 - 1698 MHz USB LCP  ''​ |\ 
-^DAS 1 Skyfreq ​      | 1650.00 |\+^DAS 1 Skyfreq ​      | 1650.00 |\ 
-^DAS 2 Skyfreq ​      | 1682.00 |\+^DAS 2 Skyfreq ​      | 1682.00 |\ 
-^Bandwidth ​         | 16 MHz         |\+^Bandwidth ​         | 16 MHz         |\ 
-^Recorder ​          | Disk             |\+^Recorder ​          | Disk             |\ 
-^DAS Mode           | vsop.pro ([[http://​www.atnf.csiro.au/​vlbi/​dasmodes/​16-2IF-1p-a.html|telescope]]) |\\ +^DAS Mode           | vsop.pro ([[http://​www.atnf.csiro.au/​vlbi/​dasmodes/​16-2IF-1p-a.html|telescope]]) |\
-\\ +
-Ftp: [[ftp://​ftp.atnf.csiro.au/​pub/​people/​vlbi/​v190/​v190d]]\\ +
-----\\ +
-\\ +
-===== Comments:\\ ===== +
-\\ +
-**TIDBINBILLA AND HOBART FREQUENCIES AND POLARISATIONS**\\ +
-\\ +
-Tid only has LCP at 1.6 GHz and should set up to record 4 channels of LCP at 256 Mbps using the vsop profile on the DAS, matched to the 4 channel frequencies given in the table. ​ This will allow Tid to match LCP at all 4 frequencies for the ATNF antennas.\\ +
-\\ +
-Likewise, Hobart should also set up to record LCP at 256 Mbps using the vsop DAS profile. ​ Like Tid this will allow LCP coverage of all 4 frequencies of the ATNF antennas, and will exactly match Tidbinbilla. ​ This setup will require splitting the RF signal and setting up two IF chains, one into each IFP of the DAS. \\ +
-\\ +
-^ IFP#1 Skyfreq ​      | 1650.00 LCP |\\ +
-^ IFP#2 Skyfreq ​      | 1682.00 LCP |\\ +
-\\ +
-**DAS & Recorder Setup**\\ +
-\\ +
-Hobart and Tidbinbilla connect DAS directly to VSIC as per normal\\ +
-\\ +
-Parkes, ATCA & Mopra connect both DAS to single VSIC input using '​Huygens'​ cable. DAS#2 should be configured to be the higher frequency and connected to input#2 (input with clock lines connected).\\ +
-\\ +
-\\ +
-**This is a disk based experiment. Do NOT delete the data after recording!!!!**\\ +
-\\ +
-Record on /​data/​removable or /data/xraid as appropriate\+
 \ \
-===== Observing comments for each antenna:\\ =====+Ftp: [[ftp://​ftp.atnf.csiro.au/​pub/​people/​vlbi/​v190/​v190d]]\ 
 +----\ 
 +
 +===== Comments:\ ===== 
 +
 +**TIDBINBILLA AND HOBART FREQUENCIES AND POLARISATIONS**\ 
 +
 +Tid only has LCP at 1.6 GHz and should set up to record 4 channels of LCP at 256 Mbps using the vsop profile on the DAS, matched to the 4 channel frequencies given in the table. ​ This will allow Tid to match LCP at all 4 frequencies for the ATNF antennas.\ 
 +
 +Likewise, Hobart should also set up to record LCP at 256 Mbps using the vsop DAS profile. ​ Like Tid this will allow LCP coverage of all 4 frequencies of the ATNF antennas, and will exactly match Tidbinbilla. ​ This setup will require splitting the RF signal and setting up two IF chains, one into each IFP of the DAS. \ 
 +
 +^ IFP#1 Skyfreq ​      | 1650.00 LCP |\ 
 +^ IFP#2 Skyfreq ​      | 1682.00 LCP |\ 
 +
 +**DAS & Recorder Setup**\ 
 +
 +Hobart and Tidbinbilla connect DAS directly to VSIC as per normal\ 
 +
 +Parkes, ATCA & Mopra connect both DAS to single VSIC input using '​Huygens'​ cable. DAS#2 should be configured to be the higher frequency and connected to input#2 (input with clock lines connected).\ 
 +
 +
 +**This is a disk based experiment. Do NOT delete the data after recording!!!!**\ 
 +
 +Disk allocations are given below under the telescope specific notes.\ 
 +
 +===== Observing comments for each antenna:\ =====
  
-| [[.:​v190dpalog | Pa]] | [[.:​v190datlog | At]] | [[.:​v190dmplog | Mp]] | [[.:​v190dholog | Ho]] | [[.:​v190dtilog | Ti]] |\\+| [[.:​v190dpalog | Pa]] | [[.:​v190datlog | At]] | [[.:​v190dmplog | Mp]] | [[.:​v190dholog | Ho]] | [[.:​v190dtilog | Ti]] |\
  
  
lbaops/lbanov2006/v190d.txt · Last modified: 2015/12/18 16:38 (external edit)