Differences

This shows you the differences between two versions of the page.

--- lbaops:parkesrx [2014/03/03 11:55]
chris.phillips
+++ lbaops:parkesrx [2019/06/19 15:36] (current)
kac014 [Multibeam (21cm, 1.4 GHz)]
@@ Line 1: / Line 1: @@
+===== Parkes Receiver Setup =====
+==== 13mm  (22 GHz) ====
+In PMCC click on the "Focus Cabin Switches". Make sure "13MM Rx" and "F/C Synthesisers" are both on - see below. If F/C Synthesisers are not on, wait ~ 1min before trying to set any of the LOs.
+In PMCC "show" the 13mm Rx settings.  Ensure LNA "A" and "B" and on and Noisecal is "active".
+{{ :lbaops:13mm-rx.png?400 |}}
+==== MARS  (8.4 GHz) ====
+In PMCC click on the "Focus Cabin Switches". Make sure "MARS Rx" and "F/C Synthesisers" are both on. (If F/C Synthesisers are not on, wait ~ 1min before trying to set any of the LOs).
+{{ :lbaops:focuscabinswitches.png?400 |}}
+==== UWB-Low  (704 MHz -- 4.032 GHz) ====
+To turn on the UWL LNAs, search for the "CS-studio" GUI on the joffrey:1 VNC session, which should look like the following image. If this is not running then it can be started from the joffrey VNC session by opening a terminal on Joffrey and typing:
+> cd UWB
+> /askap/default/bin/CSS uwb_obs.opi
+Click the "on" button under the LNA control and wait for all the lights to go green and read 'on'.
+Turn the LNAs off when your experiment is done.
+{{ :lbaops:uwb-l_lna_control.png?400 |}}
+==== Multibeam  (21cm, 1.4 GHz) ====
+On the third window of Joffrey:1, find the Parkes Monitor & Control GUI. Under Receivers, click the “show->” button that is in line with the Multibeam.
+This will bring up the MB LNA GUI.
+Select the green “On” button to turn all LNAs on. Then select the 6A LNA radio button to turn it off (it is broken).
+{{ :lbaops:mb_lnas.png?700 |}}

ATNF VLBI Wiki

User Tools

Site Tools

Differences

Page Tools