Sidebar
lbaops:parkesrx
This is an old revision of the document!
Table of Contents
Parkes Receiver Setup
13mm (22 GHz)
In PMCC click on the “Focus Cabin Switches”. Make sure “13MM Rx” and “F/C Synthesisers” are both on - see below. If F/C Synthesisers are not on, wait ~ 1min before trying to set any of the LOs.
In PMCC “show” the 13mm Rx settings. Ensure LNA “A” and “B” and on and Noisecal is “active”.
MARS (8.4 GHz)
In PMCC click on the “Focus Cabin Switches”. Make sure “MARS Rx” and “F/C Synthesisers” are both on. (If F/C Synthesisers are not on, wait ~ 1min before trying to set any of the LOs).
UWB-Low (700 MHz -- 4 GHz)
Do something to get the following window up. Click XX to enable LNA. Turn then off again when finished.
lbaops/parkesrx.1544352034.txt.gz · Last modified: 2018/12/09 21:40 by chrisphillips
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
