lbaops:xraidinstallandtest
Differences
This shows you the differences between two versions of the page.
|
lbaops:xraidinstallandtest [2007/01/25 09:55] chris.phillips |
lbaops:xraidinstallandtest [2015/12/18 16:39] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Installing a set of Apple Xraid disks\\\\ ===== | ||
| - | \\\\ | ||
| - | * The PC does not need to be shutdown to swap/ | ||
| - | > df\ | ||
| - | If any ./ | ||
| - | > umount / | ||
| - | See the troubleshooting guide if you cannot unmount the disk - alternatively just shut the machine down (but this is not recommended).\ | ||
| - | \ | ||
| - | * Turn off the Xraid power. Do this either using the power switch at the rear (hold it down for a few seconds until it starts flashing) or using the Apple rail tools java gui.\\\\ | ||
| - | \\\\ | ||
| - | * Remove any current disks - give the front panel a gentle push and a handle will pop out allowing you to pull the disks out.\\\\ | ||
| - | \\\\ | ||
| - | * Insert the disks by pushing each disk in firmly.\\\\ | ||
| - | \\\\ | ||
| - | -> """ | ||
| - | \ | ||
| - | * Once each disks is inserted, give each disk another firm push to be sure it is sitting properly. Failure to do this may cause the Xraid to think there has been a disk failure and spend the next 24hours " | ||
| - | \ | ||
| - | * Turn the power back on to the Xraid using either the power switch or java gui.\\\\ | ||
| - | \\\\ | ||
| - | * Once the Xraid is power up (check the lights on the front look OK) try and mount the disks\\\\ | ||
| - | > mount / | ||
| - | (etc)\ | ||
| - | |||
lbaops/xraidinstallandtest.txt · Last modified: 2015/12/18 16:39 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
