User Tools

Site Tools


southernhemisphereradar:observing_instructions

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
southernhemisphereradar:observing_instructions [2021/08/10 14:57]
cormac
southernhemisphereradar:observing_instructions [2021/12/16 08:49]
chrisphillips [Realtime copyig of data]
Line 10: Line 10:
   * Make sure the "8 bit" cable is connected between DAS "DigiOut" board and VSIC   * Make sure the "8 bit" cable is connected between DAS "DigiOut" board and VSIC
   * Set VSIC to mode **** (Huygens)   * Set VSIC to mode **** (Huygens)
-  * Configure DAS using ''msl_f.pro'' profile. This gives a 4 MHz band, offset from central ATCA IF frequency by XX MHz.+  * Configure DAS using ''msl_f.pro'' profile. This gives a 4 MHz band, offset from central ATCA IF frequency by -3 MHz.
  
 ==== Recording ===== ==== Recording =====
Line 22: Line 22:
    radarrecord -o EXTERIMENTNAME -t Xh    radarrecord -o EXTERIMENTNAME -t Xh
  
-==== Realtime copyig of data ====+==== Realtime copying of data ====
  
 `vsib_send` will send .lba data files when they are "complete", ie the end of 1 1 minute file in normal setup. `vsib_send` will send .lba data files when they are "complete", ie the end of 1 1 minute file in normal setup.
Line 30: Line 30:
    vsib_send -online -H cetus -p 11111    vsib_send -online -H cetus -p 11111
        
-On the receving machine (cetus in the example above)+On the receiving machine (cetus in the example above)
  
    vsib_recv -p 11111    vsib_recv -p 11111
southernhemisphereradar/observing_instructions.txt · Last modified: 2021/12/16 15:40 by chrisphillips