Next: Miscellaneous Hints Up: index Previous: SPD Contents
LBA Correlator Checklist (``Pocket Guide'')
S2 transports and console:
Day number and time on S2 recorders is correct (against master clock)
S2 mode is correct
Individual tapes are in correct order in each group.
The first S2 playback contains the tapes for the first station in the schedule file, and so on for each station in the schedule.
Tape playback times differs from real time by a multiple of 10 seconds
LBACOR:
Correct schedule loaded (using S2FILE)
Correct correlator CONFIGuration has been PROGrammed
Correct integration time and blank pulses set with CYCLE
For pulsar gating, phase offset (PSRPH) set correctly
Output data file opened or closed as required (using FO and FC)
On each "GO", check that the playback time difference in a multiple of 10 seconds
COR_DISP:
Lag spectrum for each correlator product is ok (free from obvious birdies etc)
TVD:
Phases, amplitudes and delays for all baselines/correlator products ok
Schedule file in COR$SCHED
check these settings:
EXPERIMENT expt-name
DATE year day number
FREQ/BW freq bandwidth [freq bandwidth]
SOURCE_LIST expt-name
ANTENNAS number antennas plus individual antenna information
CONFIG correlator configuration*
BASELINES number baselines* plus individual baseline information
* If CONFIG used and correlator configuration.BSL exists in COR$SCHED, BASELINES is not necessary
Check that correct STOP, FILE CLOSE, and NEWTAPES commands are commented and/or uncommented as appropriate.
Miscellaneous:
Source list expt-name.TAB exists in COR$DB and has correct positions
For pulsar gating, source_expt-name.station exists in COR$PULSAR
Next: Miscellaneous Hints Up: index Previous: SPD Contents
Paul Jones 2003-06-13